WFilter at 08:51, 16 March 2016

2016-03-16T08:51:59Z

WFilter: Created page with "{{DISPLAYTITLE:Brocade switch port mirroring setting}} = Local Port Mirroring Commands in Brocade switch = The following example configures the switch to mirror all packets ..."

2014-10-16T08:13:25Z

Created page with "{{DISPLAYTITLE:Brocade switch port mirroring setting}} = Local Port Mirroring Commands in Brocade switch = The following example configures the switch to mirror all packets ..."

New page

{{DISPLAYTITLE:Brocade switch port mirroring setting}}

= Local Port Mirroring Commands in Brocade switch =

The following example configures the switch to mirror all packets from port 6 to 5:
<pre>
Console(config)#interface ethernet 1/5
Console(config-if)#port monitor ethernet 1/6 both
Console(config-if)#
</pre>
Check mirroring status:
<pre>
Console#show port mirror
Port Mirroring
---------------------------------------------
Destionation Port (listen port): Eth1/5
Source Port (monitored port) : Eth1/6
Mode : Rx/Tx

Console#
</pre>

In this example, the WFilter pc shall be connected to port Eth1/5, while port Eth1/6 is connected to the gateway. So WFilter can monitor all internet traffic.

[[Category:Brocade]]

← Older revision		Revision as of 08:51, 16 March 2016
Line 23:		Line 23:
	In this example, the WFilter pc shall be connected to port Eth1/5, while port Eth1/6 is connected to the gateway. So WFilter can monitor all internet traffic.		In this example, the WFilter pc shall be connected to port Eth1/5, while port Eth1/6 is connected to the gateway. So WFilter can monitor all internet traffic.

		+	[[Category:Deployment]]
	[[Category:Brocade]]		[[Category:Brocade]]

Brocade port mirror/Brocade Switch - Revision history

WFilter at 08:51, 16 March 2016

WFilter: Created page with "{{DISPLAYTITLE:Brocade switch port mirroring setting}} = Local Port Mirroring Commands in Brocade switch = The following example configures the switch to mirror all packets ..."