EdgeSwitch port mirroring setting

From WFilter Documents and Tutorials
Jump to: navigation, search


Steps to enable port mirroring in an EdgeSwitch

  1. Click "System"->"Port"->"Mirroring".
  2. In session 1, click "Configure Session" to change "Mode" to "Enabled", choose "Type" as "Interface", choose "Direction" as "Tx/Rx".
  3. Choose the port connected to WFilter as the "Destination", the destination "Type" shall be "Interface".
  4. Click "Configure source", choose "Type" as "Interface", choose "Direction" as "Tx/Rx", the port connected to an up-layer device(router or firewall) shall be checked in the "available source port(s)".

Done, now traffic on the mirrored port will all be monitored and managed by WFilter.

Personal tools
Namespaces

Variants
Actions
Navigation
Tools