View source for EdgeSwitch port mirror/EdgeSwitch

{{DISPLAYTITLE:EdgeSwitch port mirroring setting}}

= Steps to enable port mirroring in an EdgeSwitch =

# Click "System"->"Port"->"Mirroring".
# In session 1, click "Configure Session" to change "Mode" to "Enabled", choose "Type" as "Interface", choose "Direction" as "Tx/Rx".
# Choose the port connected to WFilter as the "Destination", the destination "Type" shall be "Interface".
# Click "Configure source", choose "Type" as "Interface", choose "Direction" as "Tx/Rx", the port connected to an up-layer device(router or firewall) shall be checked in the "available source port(s)". 

Done, now traffic on the mirrored port will all be monitored and managed by WFilter.


[[Category:Deployment]]
[[Category:EdgeSwitch]]