Brocade port mirror/Brocade Switch
From WFilter Documents and Tutorials
(Difference between revisions)
(Created page with "{{DISPLAYTITLE:Brocade switch port mirroring setting}} = Local Port Mirroring Commands in Brocade switch = The following example configures the switch to mirror all packets ...") |
|||
| Line 23: | Line 23: | ||
In this example, the WFilter pc shall be connected to port Eth1/5, while port Eth1/6 is connected to the gateway. So WFilter can monitor all internet traffic. | In this example, the WFilter pc shall be connected to port Eth1/5, while port Eth1/6 is connected to the gateway. So WFilter can monitor all internet traffic. | ||
| + | [[Category:Deployment]] | ||
[[Category:Brocade]] | [[Category:Brocade]] | ||
Latest revision as of 16:51, 16 March 2016
[edit] Local Port Mirroring Commands in Brocade switch
The following example configures the switch to mirror all packets from port 6 to 5:
Console(config)#interface ethernet 1/5 Console(config-if)#port monitor ethernet 1/6 both Console(config-if)#
Check mirroring status:
Console#show port mirror Port Mirroring --------------------------------------------- Destionation Port (listen port): Eth1/5 Source Port (monitored port) : Eth1/6 Mode : Rx/Tx Console#
In this example, the WFilter pc shall be connected to port Eth1/5, while port Eth1/6 is connected to the gateway. So WFilter can monitor all internet traffic.
