EdgeSwitch port mirroring setting
From WFilter Documents and Tutorials
Steps to enable port mirroring in an EdgeSwitch
- Click "System"->"Port"->"Mirroring".
- In session 1, click "Configure Session" to change "Mode" to "Enabled", choose "Type" as "Interface", choose "Direction" as "Tx/Rx".
- Choose the port connected to WFilter as the "Destination", the destination "Type" shall be "Interface".
- Click "Configure source", choose "Type" as "Interface", choose "Direction" as "Tx/Rx", the port connected to an up-layer device(router or firewall) shall be checked in the "available source port(s)".
Done, now traffic on the mirrored port will all be monitored and managed by WFilter.
